Military Gear & Army Surplus Gear Blog

K-3008 w/Diesel Burner Installation, Final Test

K-3008 w/Diesel Burner Installation, Final Test



final assembly and testing remember when starting the machine always open the ball valve on the side of the pump to be sure there's water in the pump head you can check the water pump oil level in the sight glass located on the side of the high pressure water phone turn turn the to toggle switches to the op right one for the burner and one for the chemical pump to the off position now press the green button the electric motor should be turning next flush the system by squeezing the trigger on the trigger gun and holding that for about four minutes install the water nozzle in the end of the one you step on tape on the threads and tighten firmly but you're not over tighten or you may crack the clevis position the nozzle so that the two bars on the face of the nozzle are parallel with the curved surface of the spoon when you squeeze the trigger the fan of the water should be level with the curved surface of the spoon test the chemical system you can test the chemical system with water put the end of the chemical supply hose into a bucket of water turn on the machine the green button turn the toggle switch for the chemical pump to the on position with both the ball valve and the needle valve open on the one wait a few minutes until the hose has a chance to fill remember there's close to 70 meters opposed to fill you should see two streams of water coming out of the spoon on the end 21 just turn the ball valve on the one on and off to see if that stops the flow adjust the needle valve with the ball valve open and you will see the flow of the water change test the burner let go of the trigger gun on the one turn the machine on turn the toggle switch for the burner to the on position wait a minute or so but so that the fuel can be drawn into the hoses filter and fuel pump squeeze the trigger on the one the burner should light now with real acid you're ready to do high quality and high speed etching of concrete with the best machine in the industry we're always here to answer questions to help you get the most out of your Kimmel clean email us or call us


Leave a Reply

Your email address will not be published. Required fields are marked *